In stock


16 Channel IEPE Vibration Analysis System

  • Embedded Processor running Linux Kernel
  • Ethernet Connection: Gbit, RJ45 connector
  • Hard disk: 200 GB SSD
  • IEPE interface is built in
  • A/D resolution 16 bits
  • Sampling rate: 2 MS/s
  • Memory depth: 256 MB/ch
  • Bandwidth: 1 MHz
  • Recording Modes: Scope, Mulit Block, Continuous
  • Digital inputs (Markers)
  • Synchronized with analog signals
  • LXI compatible
  • IVI-Driver with sample programs for C++/C#, VB and LabVIEW
  • Device configuration over embedded Website
  • Operating Temperature: 0 .. 45 °C
  • Storage Temperature: -20 .. 60 °C
  • Rel. Humidity: Up to 31°C: < 80%
  • 31°C ..45°C: decreasing to < 50%
  • Max. Operating Elevation: 2’000m
  • Power Supply: 100 V - 250 V, 50/60 Hz
  • Power Consumption:60 W


16 Channel IEPE Vibration Analysis System

TraNET FE devices are based on an embedded microcomputer with a built in SSD storage, a Gigabit Ethernet controller and a PCI bus interface to control the installed TPCX Data Acquisition Modules. The firmware runs under a Linux operating system. This intelligent microcomputer system performs all the necessary tasks to interpret the commands received via Ethernet, handle the fast measuring data to be moved over Ethernet and/or stored onto internal hard disk. TraNET FE operates via Ethernet Link as a TCPI/IP Server. A simple point to point connection to a client PC (e.g. Notebook PC) allows an easy installation. Otherwise it can be connected to an existing LAN and therefore also allows remote operation over a practically unlimited distance Operation of TraNET devices with the TranAX (Windows software on client PC) results in a powerful Transient Recording System. In order to use the TraNET device under control of customized software, customers may be supported by Elsys with example programs.

Turnkey Solution

TraNET FE devices is developed for zero configuration networking which allows setting up a network without manual operator intervention or configuration servers. The TraNET FE device can be configured trough the built in website which is accessible over a web browser.

More Information
Number of input Channels 16 simultaneouse
Signal Type Single Ended
Sensor type IEPE piezo sensors
A/D Resolution 16 bits
Input Range ±50 mV, ±0.5 V, ±5 V, ±50 V, 0-100 mV, 0-1 V, 0-10 V, 0-100 V
Max Sampling 2 MS/s
Memory Depth 256 MB/ch
Embedded System

Linux Kernel Version 3.15.9

Internal Storage 200 GB SSD
Excitation Source 4 mA ±0.03 % of full scale

External trigger: 1

Digital Input Markers : 8

Trigger Out: 1

Digital IO

8 Ch

Multi Modules Sync 8 or 16 ports Sync-Link up to 256 ch
LXI compliance Yes
Software Packages


LabVIEW Driver

IVI Driver

TpcAccess API


Host Interface Ethernet
Dimensions 234x289x115 mm
Manufacturer Elsys
Write Your Own Review
You're reviewing:TraNET FE IEPE-404S
Your Rating